Went to two different 'gunsmiths' and they wanted to charge over $100 and one even said it would take at least 5 weeks... I was extremely upset nd disappointed. Decided to wait for this to come back into stock nd ordered it. An absolute must buy for any of the add-on pieces. Follow the instructions, use lots of wd-40 to keep temps down and lubrication, I suggest using a rag w wd-40 on it nd place inside of the receiver to catch any shavings. Clean out after your done your finished. Never did work like this before and I was done in 15 min. So useful.
Was this review helpful to you?
2 of 2 people found the following review helpful:
worked perfect
April 23, 2020
Reviewer:
Mark from Tunkhannock, PA United States
Save a lot of time, stock lined up very well.
Was this review helpful to you?
6 of 6 people found the following review helpful:
A Must Have!
March 31, 2020
Reviewer:
Charles from Texas City, TX United States
This kit is definitely a must have to precisely locate the hole on your rear trunnion. It works well if using a hand drill or drill press. If using a hand drill, I recommend working your way up to the 3/8†bit. What I did was I drilled the hole with the included 3/32†bit, then I went up to a 1/8†bit, then 1/4â€, then finally the 3/8â€. It’s not the end of the world if you happen to wander a bit as you’re enlarging the hole as the 3/8†hole is over sized compared to the stock bolt (which is why it’s better to work your way up if using a hand drill). This system is definitely easier than drilling and tapping for an ace side folder (but just as solid). Thank you CNC warrior for supporting us diy gunsmiths!
A have to 
